Page 8
•
User guide Automatic Transfer Switch
User guide Automatic Transfer Switch
•
Page 9
5 Installation
PLEASE NOTE
Before installation, please inspect the unit. Be sure that nothing inside the package is damaged.
Mounting the Unit
The unit can be mounted in a standard 19"-rack. Fasten the mounting brackets to the unit using the screws
provided. With brackets attached securely, users can mount the unit in a standard 19"-rack as shown below.
PLEASE NOTE
If the temperature around the unit will rise above 40°C, ventilation is required.
Connecting the Unit
For connecting the ATS, plug “input source A connector” and “input source B connector” to the two independent
power sources or UPSs depending using the SCHUCKO-IEC or IEC-IEC 16A cables supplied. Plug the user load
to the output 10A (“Output 1 and 2”) or 16A (“Output 3”) sockets depending on user’s requirements.
6 Operation
Power On/Off
Put the input power switch in “ON” position. The output will then be supplied by the source set as selected.
Setting priority of power source
It is possible to set the power source preference to supply the output by pushing the button of
“source preference selector”. The default power source is “Source A”.
Function
Description
Default
Possible configuration
Source perference selector
Selection of input that normally
supplies the load
Source A
• Source A
• Source B
