En-
16
Listening to the Radio
—Continued
■
Selecting Presets
To select a preset, use the number buttons on
the remote controller, the remote controller’s
arrow [
A
]/[
S
] buttons or the tuner’s PRESET
[
a
]/[
s
] buttons.
■
Deleting Presets
1
Select the preset that you want to delete.
See the previous section.
2
While holding down the [MEMORY] button,
press the [TUNING MODE] button.
The preset is deleted and its number disappears
from the display.
■
Presetting Automatically
1
Press and hold the [AUTO SCAN] button for
3 seconds to start Auto Tuning function.
Up to 40 stations can be preset and presets are
stored in frequency order.
Note:
Depending on your location, a preset may be stored with
no station and you will hear only noise when you select
it. In this case, delete the preset.
■
Name Edit
You can enter a custom name for radio preset for easy
identification. When entered, the custom name will
appear on the display.
The custom name is edited using the character input
screen.
1
Tune to the station of the preset number for
which you want to edit the name, and then
press the [SETUP] button.
2
Use the arrow [
D
]/[
F
] button to select
“Name Edit,” and then press [ENTER].
3
Use the arrow [
D
]/[
F
]/[
A
]/[
S
] button to
select a character, and then press [ENTER].
Repeat this step to enter up to 8 characters.
4
When you’ve finished editing the name and
want to store it, be sure to use the arrow
[
D
]/[
F
]/[
A
]/[
S
] button to select “OK” and
then press [ENTER]. If you fail to do this,
the name won’t be saved.
• Characters are categorized into two groups: character
set 1 primarily for lower case letters, and character set
2 primarily for upper case letters.
You can select characters in each character set by
pressing the [
D
]/[
F
] buttons.
Press the [
A
]/[
S
] buttons to select a character to input,
and then press the [ENTER] button to confirm.
If you do not find a character that you want to select in
the currently-displayed character set, press the [
D
]/
[
F
] buttons to display string “Shift
I
J
BS OK”, use
the [
A
]/[
S
] buttons to select “Shift”, and then press
the [ENTER] button to display the other character set.
• The following table shows available characters.
The meaning of commands other than alphabetical
characters, numbers and symbols is as follows:
Space:
Enters a space character.
Shift
*
:
Switches the displayed character.
I
(Left)/
J
(Right):
Select these to move the cursor within the Name
input area.
BS (Back Space):
Deletes the character to the left of the cursor.
OK:
Specifies that the entry is complete.
Tips:
* You can also perform this on the remote
controller by using
[D.TUN]
.
