6
System connections
DIGITAL IN
L
R
L
R
(PLAY)
(REC)
OUT
OPTICAL
INPUT
1
2
3
5
Improper
connection
Insert completely
4
Connecting other components
•
Do not plug in the AC power cord until all other connections have been made.
•
On each pair of input or output jacks, the jack marked R corresponds to the right channel, and the jack marked L to the
left channel. Refer to the amplifier’s instruction manual for further information on connections.
•
Do not place the MD recorder on the amplifier or receiver.
•
Do not fold optical cables into a short length or wind them up into a coil with a small radius.
•
Avoid bundling the audio connection cables with the power cord or speaker cables. Doing so may degrade sound reproduc-
tion.
•
Insert the plugs and connectors securely. Remember that improper connection can result in noise, poor performance, or
damage to the equipment.
A
Connection with the amplifier
Connect the MD-2321 to the MD (or TAPE) jacks of your
amplifier.
B
Connection via the digital input terminal (DIGITAL
INPUT)
You can perform digital recording on the MD-2321 if a CD
(Compact Disc) player or DAT (Digital Audio Tapedeck)
equipped with a digital (OPTICAL) output terminal is avail-
able. For digital recording, you need to connect the equip-
ment to either DIGITAL IN 1 or 2 terminal. Use an optical
cable to connect DIGITAL INPUT 1, and use a coaxial cable
to connect DIGITAL INPUT 2. These terminals can also be
used for connecting an amplifier which is equipped with a
digital output terminal.
Note:
•
If you attempt to perform digital recording using a digital
input terminal that is not connected properly, “D.In
Unlock” will appear.
•
Terminal protection caps are attached to the DIGITAL IN
terminals. Remove the cap for the terminal you wish to use
when connecting the MD-2321 to digital equipment.
Replace the caps if you are not using the DIGITAL IN ter-
minals.
C
Connection via the digital output terminal (DIGITAL
OUTPUT)
Connect this terminal to DIGITAL INPUT of an amplifier or
tuner amplifier to enjoy clearer and dynamic sound.
D
Connections for remote control
When the MD-2321 is connected to an amplifier with the
Onkyo
jack, pressing the MD button on the amplifier’s
remote controller enables you to operate the MD recorder.
Note:
•
The upper and lower
remote control jacks have the
same function.
•
Remote control operation is not possible when only the
remote control cable is connected – the audio cables must
also be connected.
E
Connecting the AC power cord and turning the
power on
1. Insert the AC power cord into a wall outlet.
2. Press the STANDBY/ON button.
The display will light.
Note:
To insert the AC power cord into an AC outlet on the rear panel
of another component, use the UNSWITCHED outlet.
To AC outlet
Connecting an Onkyo product
Amplifier without
CD player, DAT, etc.
Amplifier, Tuner amplifier
with digital inputs
digital inputs
Analog input
Analog output
with connectors enables you
to use the System function.
4
