MD-101A
C P L AY M O D E
C - P L AY M I D
C 1 = X X X X A D = X X
C - P L AY O U T
C 1 = X X X X A D = X X
C - P L AY I N
C 1 = X X X X A D = X X
6
C R E C M O D E
C R E C O U T
C R E C ( 0 7 0 0 )
C R E C O U T
C R E C M I D
C R E C I N
CREC (0700)
CREC (0300)
CREC (0040)
FL Display
ADJUSTMENT PROCEDURES-8
Check of the error rate by the MO disk
[Preparation]
[Check]
C1 error rate
(1) Turns the
JOG
knob and select the
C P L AY M O D E .
(2) Press the
JOG
knob.
(3) Check that the value of C1 error rate is the
value
less than 50.
(4) Check the error rate in
OUT
(perimeter portion of disk)
by pressing the
JOG
knob once again.
(5) Check the error rate in
IN
(inner circumference portion
of disk) by pressing the
JOG
knob once again.
(6) Press the
EDIT/NO
button .
(7) Press the
STOP
button .
(8) Take out disk from the unit by pressing
the
EJECT
button.
This value is usually
less than 30.
Make the continuation recording disk used for the check of the error rate.
(1) Loading of the MO disk (standard recordable disk).
(2) Select the
CREC MODE
in the state in test MODE.
(3) Press the
JOG
knob so that the display may
be
CREC OUT
.
(4) Recording is started.
Continue the recording for required time at the CREC OUT, CREC IN and CREC MID mode.
(5) Press the
STOP
button after recording is completed.
When an extremely large value comes out at an error rate, it may not be recorded normally.
Please check that recording of area which checks an error rate is performed with refer to "Preparation"
[NOTES]
If the disk created by other sets is used, since the check with normal recording cannot be performed,
please carry out self-recording reproduction with the same set.