Onkyo DR-S501, Инструкция по эксплуатации

Страница: 18 / 84

18
Connecting the DVD receiver —Continued
Connecting the Speaker Cables
The following illustration shows which speaker should
be connected to each pair of terminals.
Connecting a Powered Subwoofer
Using a suitable cable, connect the DVD receiver’s SUB-
WOOFER PRE OUT to an input on your powered sub-
woofer, as shown.
Speaker Impedance
If the impedance of any of front speakers is 4 ohms or
more but less than 6, set the speaker impedance to
“4
:
~16
:
”.
Note:
Change of the settings may be required for some speak-
ers (see page 55).
1
Strip about 15 mm of insu-
lation from the ends of the
speaker cables, and twist
the bare wires tightly, as
shown.
2
Unscrew the terminal.
3 Fully insert the bare
wires.
4
Screw the terminal tight.
15 mm
Front right
speaker
Front left
speaker
LINE INPUT
LINE INPUT
Powered
subwoofer
Use the SPEAKER IMPEDANCE SELEC-
TOR to select speaker impedance.
4
:
~16
:
:
Select if the impedance of any of speakers is 4
ohms or more but less than 6.
6
:
~16
:
:
Select if the impedances of all speakers are
between 6 and 16 ohms.
SPEAKER IMPEDANCE
SELECTOR