121
Multi Zone
—Continued
Notes:
• Only analog input sources are output by the ZONE 2/
3 PRE OUT and ZONE 2/3 L/R speaker terminals.
Digital input sources are not output. If no sound is
heard when an input source is selected, check if it’s
connected to an analog input.
• You cannot select different AM or FM radio stations
for your main room and Zone 2/3. The same AM/FM
radio station will be heard in each room. For example,
if you have an FM station for the main room, that sta-
tion will also be used in Zone 2.
• When you connect Zone 2 speakers directly to the AV
receiver, listening modes that require surround back
speakers or front high speakers or front wide speakers
(6.1/7.1), such as Dolby Digital EX, DTS-ES, THX
Select2 Cinema, Dolby Pro Logic IIz height, and
Audyssey Dynamic Surround Expansion™ are
unavailable.
• When you connect Zone 3 speakers directly to the AV
receiver, listening modes that require surround speak-
ers are unavailable.
• When the input selector of Zone 2/3 is selected, power
consumption on standby mode slightly increases.
• While Zone 2/3 is on,
u
functions will not work.
Adjusting the Volume for Zones
Muting Zones
Adjusting the Tone and Balance of Zones
Notes:
• Zones can also be unmuted by adjusting the volume.
• The Zone 2 volume, tone, and balance function have
no effect on the ZONE 2 PRE OUT when the “Zone2
Out” setting is set to “Fixed” (page 119).
• The Zone 3 volume, and balance function have no
effect on the ZONE 3 PRE OUT when the “Zone3
Out” setting is set to “Fixed” (page 119).
• Even if you repeatedly press the remote controller’s
[ZONE] button to select zones, the last zone selection
will be retained once you have switched to other com-
ponents by pressing other REMOTE MODE buttons
after pressing the [ZONE] button.
Remote
controller
On the remote controller, press
the [ZONE] button repeatedly,
and then use the VOL [
q
]/[
w
]
button.
AV receiver
On the AV receiver, press the
[ZONE 2] or [ZONE 3] button (the
ZONE 2/3 indicator and Zone 2/3
selector on the display flashes)
and press [LEVEL] button
followed by the [
e
]/[
r
] buttons
within 8 seconds.
Remote
controller
On the remote controller, press
the [ZONE] button repeatedly,
and then press the [MUTING]
button.
To unmute a zone, on the remote
controller, press the [ZONE]
button, and then press the
[MUTING] button again.
1
AV receiver
On the AV receiver, press the
[ZONE 2] or [ZONE 3] button.
2
Press the AV receiver’s [TONE]
button repeatedly to select
“Bass”, “Treble” or “Balance”.
3
Use the Right [
r
] and Left [
e
]
buttons to adjust the bass, treble
or balance.
• You can boost or cut the bass or tre-
ble from –10 dB to +10 dB in 2 dB
steps.
• You can adjust the balance from 0 in
the center to +10 dB to the right or
+10 dB to the left in 2 dB steps.
TX-NR807_En.book Page 121 Tuesday, July 28, 2009 12:00 PM
Содержание 29400021
Страница 147: ...147 Memo ...
