Depending on when you purchased your RS1000’s, your amplifier may not look exactly like the one
shown here. The amps are essentially the same but early versions have the high level and low level
input and output positions reversed. Additionally, the power cord inlet and fuse are in a different
location.
1 - Crossover. Where you set this
dial indicates the highest fre-
quency that will be output by the
woofer.
2 - Phase. This controls the phase
of the woofer.
3 - Level. This controls the gain
of the amplifier / the SPL level of
the woofer.
4 - High level input. These accept
a speaker level signal.
5 - High level output. These out-
put a speaker level signal.
6 - Low level input. These accept
a low level or line level signal.
7 - Low level output. These out-
put a low level or line level signal.
8 - Power switch.
9 - IEC power cord inlet. Above
contains the fuse for the
amplifier.
