Page 3
1)
Clear the floor of any materials or objects.
2)
Ensure handle is in the storage position
(straight up) and locked in place with the
quick release pin.
3)
Tilt the machine back until the handle is
laying on the floor and the three heads are
fully exposed.
4)
Select the accessory set required for the
job.
5)
Snap the accessory set onto the four metal
pins protruding from each of the three heads.
6)
To replace, pull off the current accessory set
and replace with the new accessory set.
7)
Carefully raise the handle, supporting the
axle with your foot to control the machine
head as it is placed on the floor.
8)
Shift handle to the operating position and
lock in place with the quick release pin.
DO NOT
attempt to operate this unit if the machine is not fully assembled.
When servicing or replacing an accessories turn
OFF
the machine and
disconnect from the power source.
Prior to operating the machine, tilt machine back on transport wheels,
turn
ON
the machine and carefully lower the machine onto the working surface.
CAUTION:
A
TTACHMENTS
I
NSTALLATION
& C
HANGING
When installing or changing the accessories, turn
OFF
the sander
and disconnect the power cord from the electrical outlet.
Before Installation or Changing of
Attachments:
1)
Unplug the sander from the wall outlet.
2)
Ensure handle is in the storage position
(straight up) and locked in place with the quick
release pin.
3)
Tilt machine back by bracing it with your
foot until the handle is laying on the floor and
the three heads are fully exposed.
Note:
It is recommended that a towel or pad is
placed under the machine to protect the floor.
Changing and Installation the
Attachments
1)
Position the first attachment head at 12
o’clock.
2)
Using both hands, reach beneath the bot-
tom side the attachment and pull up towards
yourself to free it from the sander.
3)
Select the attachment required for the job,
and line up the holes on the attachment with
the four metal pins protruding from each of the
three heads.
4)
Push the attachments on by hand and if nec-
essary, carefully tap it into place with a rubber
mallet.
5)
Repeat steps 1 thru 4 with the remaining 2
attachments.
6)
Carefully raise the handle, supporting the
axle with your foot to control the head of the
machine as it is placed on the floor.
7)
Since the attachments are different heights
you may need to adjust the dust skirt to make
sure it is level with the attachments. This will
ensure clean and virtually dust-free operation.
9)
To adjust skirt, align the skirt with the center
of the machine and wrap it around.
10)
Move the handle back to the operating
position and lock in place with the quick
release pin.
CAUTION:
When installing or removing attachments, always wear protective gloves and start at the 12 o’clock position.
F
LOOR
M
ACHINE
O
PERATING
I
NSTRUCTIONS
