9
Combined Super Gorilla Owner’s Manual © O.A.S. 2010
VII. Bracket Assembly
1. You must determine the direction the fan outlet will point to proceed
with this mounting assembly. The collector will seem quieter if the outlet
is aimed away from the area people tend to work. Slots in the brackets
are .406” x 1.00”.
Note: Bolts included to mount bracket to collector. Hardware NOT
included to mount to wall.
2. Hold bracket against wall with top of plate at 56”. Mark where mount-
ing holes fall. Mount wall bracket. For wall mounting, the bolt centers on
the brackets are at 16” & 24” to accomodate most wall stud spacing. See
Fig. 1 & 2. Use a level to ensure straightness.
3. Attach bracket to wall with lag screws, concrete anchors, or other
suitable hardware. See Fig. 2 & 3. Note: When installing the brackets on
a concrete wall, mount 2 x 4’s between wall and brackets to stabilize and
dampen vibration.
4. Position Angle Ring around top of cone over bracket. Line up one hole
in ring with hole in each bracket at desired rotation of outlet. If rotation
you desire does not correspond to an existing hole in Angle Ring, drill
new ones. Use three 3/8” bolts (included) with washers & lock washers
to secure the fan. See Fig. 4.
5. Attach tightly with bolts.
24”*
26 1/4”
15 7/8”
11 1/4”
Put at 69” if you
are using a 55
gal. drum.
16 1/4”
Flex Hose Connection Cone to Drum
Distance between drum lid and cone can vary. Some systems have little space there to minimze overall system height. The
hose is used to seal between the drum and system and needs only enough height to allow the lid of the drum to come off. In
some cases the flex hose will have to be cut down (especially with stands or when mounting the system as low as possible).
OAS ships 1’ of hose as standard but this is not necessarily the needed length once the system is installed.
Tools needed to shorten hose: razor knife and diagonal cutters.
Measure length between drum lid and collar of cone. Measure hose while it is extended (don’t overly compress the hose).
This allows the lid to move up when installed. Cut the hose with razor knife and then cut the wire with diagonal cutters
Don’t cut too short... if in doubt, cut a little long. Trim if necessary.
* only 5hp Bracket has 24” holes
