Oneida Air Systems BenchTop DC, Руководство пользователя

Страница: 14 / 20

Oneida Air Systems, Inc. 12
Troubleshooting
Ÿ
If you continue to experience difficulty with your dust collector, call Oneida Air Systems’ Customer Service
Department at 1-866-387-8822 or e-mail support@oneida-air.com.
PROBLEM CAUSE SOLUTION
System has Low or no
Suction Filter is clogged 1. See Filter Replacement section on page 10.
Motors not working
1. Unlatch the two draw latches and slide the Frame Assembly (E) out and away from
the Fan Assembly (B).
2. Visually inspect that all fans are spinning by switching the unit on/off.
3. If any fans are not spinning, turn off and unplug the BenchTop DC and wait for the
Fan Assembly to come to a complete stop and for the dust to settle.
4. Remove back cover of the Fan Assembly with Phillips screw driver and check that
the three wires are connected between each motor and control board; reattach
wires as necessary.
Variable Adjustment Knob
not Working Loose Wire in the Fan Assembly 1. Turn off and unplug the BenchTop DC and wait for the Fan Assembly to come to a
complete stop and for the dust to settle.
2. Remove back cover of the Fan Assembly with Phillips screw driver and check wiring
connection between adjustment knob and control board.
Switch isn’t working Cord unplugged
1. Ensure the unit has adequate power supply .
2. Ensure the AC Cord is fully seated.
3. Turn off and unplug the BenchTop DC and wait for the Fan Assembly to come to a
complete stop and for the dust to settle.
4. Remove back cover of the Fan Assembly with Phillips screw driver and check wiring
connection power inlet and switch, between the switch and the power supply, and
between the power supply and the control board.
The supplemental outlet
isn’t generating power to
my attached tool Loose Wire in the Fan Assembly
1. Turn off and unplug the BenchTop DC and wait for the Fan Assembly to come to a
complete stop and for the dust to settle.
2. Remove back cover of the Fan Assembly with Phillips screw driver and check wiring
connection between adjustment knob and control board.

UNPLUG YOUR UNIT BEFORE SERVICING OR CLEANING.