Manual pairing to transmitter
1.
Turn on the ONEwoofer and enter speaker menu
2.
Choose “Pair speaker”, enter pairing mode and you will hear “Pairing”
3.
Set transmitter (ONEdongle or ONEbox) into pairing mode.
3a. ONEdongle
i. Plug the ONEdongle into ONEwoofer’s USB port.
ii. USB dongle LED will blink, indicating it is in the pairing mode
iii. Wait about 10-60s, you will hear “Paired with stereo dongle”
3b. ONEbox
There are 3 ways to set ONEbox into pairing mode:
i. Power up ONEbox, during the first 45s of the power up initializing time, ONEbox is in pairing mode and
ready to add new speakers. No key is needed. When it detects new speakers in paring mode, it will start
pairing, blinking red LED will change to toggling blue and red LED
OR
ii. When ONEbox is in standby mode, press and hold the left key [-] for 2 seconds to enter pairing mode,
blue LED and red LED will toggle.
OR
iii. Go to mobile control homepage, and then go to speaker setup page
touch “Add speaker” to
enter pairing mode, blue LED and red LED will toggle
iv. When pairing is successful, you will hear “Paired with micro box”
Note: If you have two transmitters to pair, you have to do the pairing one by one.
Subwoofer volume
During ONEwoofer is playing, press [+] key can increase subwoofer volume by 1dB, press [-] key can decrease
subwoofer volume by -1dB. Stereo 2.1 mode and surround 5.1 mode have individual volume, you can set different
subwoofer volume level in stereo and surround play.
USB port
The USB port of the ONEwoofer can supply 0.5A current output, it is used to :
Pair speaker
Supply power for ONEbox.micro
Firmware upgrade (with special FWU tools)
If overloaded current is detect, you will hear warning “Over current, please plug out USB device on USB port”
Never use the USB port for portable speaker charging, over current drain on the port will damage the subwoofer.
Enable stereo 2.1 mode
For both ONEdongle and ONEbox, stereo 2.1 mode will be automatically enabled when you turn on the ONEwoofer.
Audio sound mode 2.0 and 2.1 will be switched automatically apply to main speaker and subwoofer.
Standby mode & Power off
When ONEwoofer is not playing, it will always stay in the standby mode. If you want to switch off the subwoofer,
short hold [PWR] key to turn it off. Press again can turn the subwoofer on.
