One Stop Systems, Inc. OSS-lanAMC-4GC User Manual
Rev. A
3
Installation and Removal
1. Power down the host system.
2. Let the power supply cool down, if necessary.
3. Remove the carrier board from the system. (For ATCA installations)
4. Remove the OSS-lanAMC-4GC from the protective bag, observing proper ESD safety procedures.
Installing
the OSS-lanAMC-4GC:
1. Remove any debris from the EMC shielding along the sides of the module.
2. Align the AMC module with the top and bottom card guides.
3. Slide the module all in the way firmly seating the connector.
4. Make sure that the AMC modules gaskets seal the surfaces that they touch
5. Attach the ethernet cables.
6. Turn on power to the computer. Module installation is complete.
7. Reverse the above procedure to remove the board
Specifications
Electrical/Mechanical Specifications
Form Factor:
AdvancedMC Single Width, full height
Dimensions (H x L):
6HP x 74mm
Front Panel Connectors:
Four RJ45 connectors
Front Panel Indicators:
4 Link and Actvity LEDs
Power Consumption (designed to meet the following conditions
6.4W max @12V
Operating Environment (designed to meet the following conditions)
Temperature Range:
0° to 55°C (32° to 131°F)
Relative Humidity:
5 to 90% non-condensing
Shock:
30g acceleration peak (11ms pulse)
Vibration:
5-17 Hz 0.5” double amplitude displacement; 7-2000Hz, 1.5g acceleration.
Agency Compliance Designed to meet, but not tested
FCC Class B, UL 60950, CE Mark, CS-003
