INSTALLING BATTERIES
1. On the remote control’s back, push the tab and lift off the battery
cover.
2. Obtain two (2) new AAA alkaline batteries. Match the + and –
marks on the batteries to the + and – marks in the battery case,
then insert the new batteries.
3. Press the battery cover back into place. The tab should click when
the cover is locked.
4. Test the unit by pressing
POWER
and any mode key (e.g.,
TV
). If the
batteries are inserted correctly, the LED will blink once.
NOTE: When batteries need replacement, the remote control will stop operating.
Remove the old batteries and insert new ones within 30 minutes to ensure all of
your programming information is restored.
Battery Precautions:
Do not mix old and new batteries.• Do not mix alkaline, stan-
dard (carbon-zinc) or rechargeable (nickelcadmium)batteries.• Always remove old,
weak or worn-out batteries promptly and recycle ordispose of them in accordance with
Local and National Regulations.
SETTING UP YOUR COMPONENTS
The One For All 3 Devices remote control is preprogrammed at the fac-
tory to operate an RCA TV and VCR, a Motorola (GI) cable box, and a
Toshiba DVD player. To control devices other than the default brands,
perform the following steps; otherwise skip this section:
NOTE: For TV/VCR Combo control, see the next section.
1. Turn on a device (e.g.,VCR) and, if applicable, insert media, (e.g.,
cassette or disc).
NOTE: Please read steps 2-4 completely before proceeding. Highlight or write
down the codes and device you wish to program before moving on to step 2.
2.
On the remote control, press a device key once (i.e.,
VCR/DVD
,
CBL/SAT
, or
TV
). Press and hold
SET
until the LED blinks twice,
then release
SET
.
3. Use the
Manufacturer’s Codes
(starting on page 11) to locate the
type of device and brand name and then enter the first four-digit
code for your component. If performed correctly, the LED will blink
twice.
5