O
WNER
’
S
M
ANUAL
Using Learning 13
•
Learned keys are mode specific, so
each one can store a unique function
for each mode.
•
Learned keys can be used in macros
(see “Using Macros” on page 10).
•
Do not use the following keys for
learning: Device Keys,
SETUP
,
FAV
, or
Record (
•
) Key.
•
Learning capacity is approximately 50
to 70 keys, depending on the code
being learned.
•
If both learned and keymoved
functions are assigned to the same key,
the last programmed function is
stored.
•
A learned function cannot be used as a
source for Keymover (see “Using
Keymover” on page 14).
•
Certain device codes are not learnable
including multi-frequency types, some
high frequency ones, and other
unusual formats.
•
For optimum learning, avoid high
levels of ambient light such as natural
sunlight or energy-efficient fluorescent
lights.
NOTE:
Please have your original remote
controls handy before programming learning.
Be sure to press each teaching key within 5
seconds of the previous entry. Otherwise, the
One For All 10L Universal Remote Control
with Learning (URC-10820 B00) exits the
learning mode.
P
ROGRAMMING
A
L
EARNING
K
EY
1.
Press and hold
SET
until the LED (red
light) blinks twice, then release
SET
.
2.
Enter
9 7 5
. The LED will blink twice.
3.
Press a device key once (e.g.,
TV
) to
assign a mode for learning.
4.
Press the desired key once (e.g.,
L1
) to
store a feature to be learned. The LED
will turn on and remain on for 5
seconds. If the LED does not turn on,
go back to step 1 and start again.
5.
Place your original remote control
(e.g., TV remote control) head-to-head
(about 2" apart) from the One For All
10L Universal Remote Control with
Learning (URC-10820 B00).
6.
On your original remote control, press
and hold the key (i.e., feature) to be
learned until the LED on the One For
All 10L Universal Remote Control with
Learning (URC-10820 B00) turns off
and then blinks twice. If the LED does
not blink twice, repeat steps 3 through
6.
7.
To learn functions onto other learning
keys (e.g.,
L2
and
L3
), repeat steps 3
through 6.
8.
To lock in new feature(s) on the One
For All 10L Universal Remote Control
with Learning (URC-10820 B00), press
and hold
SET
until the LED blinks
twice, then release
SET
.
9.
To test a learned feature, press a device
key (e.g.,
TV
) once where the learning
mode was assigned. Then press the
learning key (e.g.,
L1
) where the
learned feature is stored.
D
ELETING
F
UNCTIONS
FROM
THE
L
EARNING
K
EYS
1.
Press and hold
SET
until the LED (red
light) blinks twice, then release
SET
.
2.
Enter
9 7 6
. The LED will blink twice.
3.
Press the device key once where the
learned feature is stored (e.g.,
TV
).
OFA 10L with Learning Owners Manual.fm Page 13 Thursday, January 27, 2005 1:34 PM
