NIS54xxGEVB
http://onsemi.com
NIS545x Controlled slew rate
Continue with jumpers J2 (10 Ω), J1 (545x), J4, and J13. Perform this test with and without the J6 jumper
in place to observe how the duration of the controlled slew rate changes. When J6 is in place, the slew rate will be
longer because a capacitor is connected between the dv/dt pin and GND. With VCC set to 5 V, press and release the
blue button to see the eFuse turn on with a controlled output voltage slew rate.
Figure 13. This is a demonstration of the controlled slew rate circuit with J6 in place. Without J6
in place, the slew rate will be lower.
