NCP102 Demonstration Board Test Procedure
Figure 1 Test Setup
1/22/08
1 of 4
REV 1
Страница 1: ...NCP102 Demonstration Board Test Procedure Figure 1 Test Setup 1 22 08 1 of 4 REV 1...
Страница 2: ...um current rating of 2ADC for example Keithley 175 3 1 Electronic Load possessing a current display and minimum current capability of 4 ADC for example Kikusui PLZ303W Test Procedure Establish Setup 1...
Страница 3: ...banana cable to N_Enable or adjust the N_Enable supply output to 4 5VDC 7 If Vcc 12 0VDC DMM 1 go to Full Load Regulation and Enable Function below 8 Adjust the Vcc supply to 12 0VDC as indicated on D...
Страница 4: ...12 10 Adjust the Vcc supply to 5 0VDC as indicated on DMM 1 11 Repeat steps 1 through 9 of this section 12 Verify that Vout DMM 3 equals zero VDC 13 Test complete Revision History Revision Release Dat...
