MT9F002I12STCUH
−
GEVB
4
(continued)
Jumper/Header No.
Description
Pins
Jumper/Header Name
P8
+2V8_VAAPIX
1
−
2 (Default)
Connects to on-board +2V8_VAAPIX power supply
2
−
3
External power supply connection
P11
ATEST
Open (Default)
For test/debugging
P12
GPI0
Open (Default)
For various sensor settings
P13
GPI1
Open (Default)
For various sensor settings
P14
GPI2
Open (Default)
For various sensor settings
P15
GPI3
Open (Default)
For various sensor settings
SW1
TEST
Off (Default)
Normal Operation
On
Test Mode
SW4
SADDR
Off (Default)
I
2
C address set to 0x20
On
I
2
C address set to 0x30
SW5
SHUTTER
Off (Default)
Turn on +5V LED indicator
On
Turn off +5V LED indicator
SW6
EEPROM ADDR
A2 On,
A1 Off (Default)
EEPROM Address set to 0xA8
A2 On,
A1 On
EEPROM Address set to 0xAC
A2 Off,
A1 On
EEPROM Address set to 0xA4
A2 Off,
A1 Off
EEPROM Address set to 0xA0
SW7
ON_LED
On (Default)
Turn on +5V LED indicator
Off
Turn off +5V LED indicator
SW9
CLK_SELECT
Off (Default)
Connects to on-board oscillator
On
Connects to output from P10 header
SW10
RESET
N/A
When pushed, 240 ms reset signal will be sent to MT9F002
Interfacing to ON Semiconductor Demo 2X Baseboard
The ON Semiconductor Demo 2X baseboard has a
similar 26-pin connector and 13-pin connector which mate
with J3 and J4 of the headboard. The four mounting holes
secure the baseboard and the headboard with spacers and
screws.
Shorted Jumpers for power measurement
Different supplies to the evaluation board are provided by
trace shorted jumper, for any voltage and power
measurements. To conduct current for current measurement
on a given power rail, cut the trace between the two pins of
their respective JP, and insert an ammeter prior to powering
up the system. The figure below shows where the trace to cut
is located.
Table 2. SHORTED JUMPERS FOR POWER
MEASUREMENT
Jumper
Voltage (V)
P14 (+5V0)
5.0
Figure 8. Top and Bottom View of Shorted Jumper. The Bottom View Shows the Trace Location to
Cut for Current Measurement
Cut Here
