AP0100CSSL00SPGAH−GEVB
www.onsemi.com
5
Table 1. JUMPERS AND HEADERS
(continued)
Jumper/Header No.
Description
Pins
Jumper/Header Name
P38, P39
IO Expander U38
Setting
P39 Open,
P38 Closed (Default)
EEPROM Address Set to 0x48
P39 Open,
P38 Open
EEPROM Address Set to 0x4C
P39 Closed,
P38 Open
EEPROM Address Set to 0x44
P39 Closed,
P38 Closed
EEPROM Address Set to 0x40
P40
GPIO_DATA17
1−2 (Default)
Auto-Configuration Access
Open
JTAG/UART Access
P41
GPIO_DATA18
1−2 (Default)
Auto-Configuration Access
Open
JTAG/UART Access
P42
GPIO_DATA19
1−2 (Default)
Auto-Configuration Access
Open
JTAG/UART Access
P43
SP1_SDO/SDI
1−2 (Default)
Beagle SPI No Access to Sensor SPI
Open
Beagle SPI Access to Sensor SPI
P44
P44
SP1_SCLK/CS_N
1−2 (Default)
Beagle SPI No Access to Sensor SPI
Open
Beagle SPI Access to Sensor SPI
P45
SPI_SDI
Open (Default)
Data or GND; AP0100 in Flash/Host Mode
1−2
High Z; AP0100 in Auto-Config Mode
P47, P48, P59
Serial I
2
C EEPROM
Address
P47 Closed,
P48 Open,
P59 Open
EEPROM Address Set to 0xAA (Default)
P47 Closed,
P48 Open,
P59 Open
EEPROM Address Set to 0xA2
P47 Open,
P48 Closed,
P59 Open
EEPROM Address Set to 0xA6
P47 Open,
P48 Open,
P59 Open
EEPROM Address Set to 0xAE
P49
SEN_SCLK
2−3 (Default)
AP0100 Serial Control
1−2
Demo 2X Serial Control
P50
SEN_SDATA
2−3 (Default)
AP0100 Serial Control
1−2
Demo 2X Serial Control
P51
SEN_RST_OUT
2−3 (Default)
AP0100 Reset
1−2
Demo 2X Reset
P52
BEAGLE_SCL
1−2 (Default)
Demo 2X Accessed
2−3
Sensor Accessed
P53
BEAGLE_SDA
1−2 (Default)
Demo 2X Accessed
2−3
Sensor Accessed
P54
1OE/2OE
1−2 (Default)
Enable Level Transistor U9
2−3
Disable Level Transistor U9
P56, P57, P58
Video Filter Selection
1−2 (Default)
Active Low Pass Filter
2−3
Discrete Low Pass Filter
SW7
RESET
N/A
When Pushed, 240 ms Reset Signal will be Sent to
AP0100 Chip
