Omron ZR-RX70, Руководство пользователя

Страница: 72 / 127

Setting Menus
70
ZR-RX70 User’s Manual
(3)-1 Timer Mode
Sets the timer function.
When the timer function is used (set to a selection other than OFF), data capture is enabled only during the
time for which the timer is set.
The actual timing conditions for data capture are related to triggers.
See also Sections “(3)-2 Start Side Source Settings” p. 70, “(3)-3 Stop Side Source Settings” p. 71,
and “(3)-7 Timer Trigger Information” p. 72.
(3)-2 Start Side Source Settings
Specifies trigger conditions to start data capture.
The actual timing conditions for data capture are related to the timer.
See also Sections “(3)-1 Timer Mode” p. 70, “(3)-3 Stop Side Source Settings” p. 71, and “(3)-7 Timer
Trigger Information” p. 72.
Selection Description
Off The timer function is not used. Data capture starts according to triggers.
Date and Time Data capture starts when a trigger is generated only during certain (specified) date and
time.
⇒
When Date and Time is selected, set the date and time both on the start and stop
sides.
Every Day Cycle Data capture starts when a trigger is generated only during the same (specified) time
every day.
⇒
When Every Day Cycle is selected, set the time (hour and minute) both on the
start and stop sides.
Every hour cycle Data capture starts when a trigger is generated only during the same (specified) time
every hour.
⇒
Set the time (minute and second) both on the start and stop sides.
Selection Description
Off Starts capturing data unconditionally (when the [START/STOP] key is pressed or the
time specified for the timer function arrives).
Level Starts capturing data when a specified level condition is met.
⇒
When Level is selected, set the condition for each channel.
See p.72.
External Input Starts capturing data when an input signal is received from an external trigger terminal.
* A trigger is generated when the voltage changes from 5V (open) to 0V (short circuit
to GND).
Time Data capture starts after a specified length of time elapses after the [START/STOP] key
is pressed or the time specified for the timer function is reached.
⇒
When Time is selected, set the time to start capturing data.