Omron SYSMAC W398-E1-1, Руководство по эксплуатации

Страница: 17 / 127

3
Introduction Section 1-1
Individual Copying and
Moving of NC Unit Data NC Unit data, such as parameters, sequences, and speeds, can be moved or
copied (overwritten) between PCs in the project tree. This feature enables
editing and re-use of the same or similar data with other PCs or NC Units.
Communications with NC
Units via Networks The CX-Position communicates with NC Units using FinsGateway. Depending
on the type of FinsGateway driver used, online operations (e.g., monitoring
and transfer/verification of parameter and sequence data) are possible via
Host Link (SYSWAY-CV) or Ethernet.
Automatic Project
Generation The CX-Position can read information about the NC Units mounted on a PC
connected online, and automatically create a project based on this informa-
tion. (CX-Position can also upload actual data from NC Units and use it in the
project.) This feature eliminates the necessity of creating a new project offline
before going online.
Importing SYSMAC-NCT
Data Data created for the C200HW-NC
@@@
using the SYSMAC-NCT (with “.ncm”
file extension) can be imported and used as data for the CS1W-NC @@@ or
CJS1W-NC @@@ .
1-1-4 Applicable Computers
The CX-Position can be used on computers that satisfy the following condi-
tions.
1-1-5 CX-Position Data
The CX-Position is used to make project files with the configuration shown
below. The file extension for project files is “.nci”.
1-1-6 Software Structure
The CX-Position exchanges data (online communications) with NC Units via
FinsGateway. In order to execute functions online, either FinsGateway Version
2 Embedded Edition or FinsGateway Version 3 Embedded Edition must be
installed on the same computer as CX-Position.
FinsGateway Version 3 Embedded Edition is included on the setup disk.
Item Requirement
Computer IBM PC/AT or compatible
Operating system Windows 95, 98, 2000, or NT 4.0
CPU Pentium 100 Mhz or higher
Memory 32 Mbytes min.
Hard disk drive 100 Mbytes min.
CD-ROM drive 1 min.
Monitor SVGA (800
×
600 pixels) min.
PC
PC
NC
NC
NC
NC
NC
Project file (“.nci”)
1,000 PCs max.
Parameter data
Sequence data
Speed data
Acceleration/deceleration data
Dwell times
Zone data
One “PC” contains the data for 1
PC (CPU Unit). One project file can
contain up to 1,000 PCs. One “NC”
contains all the data for 1 NC Unit.
96 Units max. (See note.)
Note The number of NC Units is
restricted by the number of
allocated unit numbers and
the current consumption.