Omron Q2V Series, Техническое руководство

Страница: 615 / 734

Parameter
Details
12
12.7 H: TERMINALS
SIEPCYEUOQ2V01A Q2V Technical Manual 615
Torque Limit Configuration Method
Use one of these methods to set torque limits:
• Individually set the four torque limit quadrants using L7-01 to L7-04 [Torque Limit] .
• Use MFAI to individually set the four torque limit quadrants. Set H3-02, H3-10 = 9, B, C [MFAI Function
Select = FW Trq Lim, Rev Trq Lim, RegenTrqLim] .
•
Use MFAI to set all four torque limit quadrants together. Set H3-02, H3-10 = D [GenerTrqLim] .
•
Use a communication option to set all four torque limit quadrants together.
Figure 12.92 shows the configuration method for each quadrant.
Figure 12.92 Torque Limits and Analog Input Setting Parameters
Note:
•
When L7-01 to L7-04 and analog inputs or communication option torque limits set torque limits for the same quadrant, the lower value
is enabled.
In this example of parameter settings, the torque limit for quadrant 1 is 130% and the torque limit for quadrants 2, 3, and 4 is 150%.
Settings:
L7-01 = 130% , L7-02 to L7-04 = 200% , and MFAI torque limit = 150%
•
The drive output current limits maximum output torque. The torque limit is 150% of the rated output current for HD and to 120% of
the rated output current for ND. The actual output torque is not more than the limits of the drive rated output current when you set the
torque limit to a high value.
If you use drives in applications where the vertical axis can fall, make sure that you know these items:
• Correctly configure drives and motors.
• Correctly set parameters.
• You can change parameter values after you do Auto-Tuning.
• Use a system that will not let the vertical axis fall if the drive fails.
Figure 12.93 shows the relation between torque limits from parameters and torque limits from analog input.
Figure 12.93 Torque Limits from Parameters and Analog Inputs