Omron NYP - 1 Series, Руководство пользователя по оборудованию

Страница: 141 / 266

Wire External I/O Signal Lines
Observe the following points when wiring the external I/O signal lines.
• To absorb reverse electromotive force when an inductive load is connected to an output signal, con-
nect a surge suppressor near the inductive load in an AC circuit, or connect a diode near the induc-
tive load in a DC circuit.
Input Signal Noise Countermeasures
DC
Input
Unit
Inductive
load
Diode
Connect a diode in a DC circuit.
Output Signal Noise Countermeasures
Output
Unit Output
Unit
Connect a diode
in a DC circuit. Connect a surge
suppressor in an AC circuit.
Inductive
load
Diode Inductive
load
Surge
suppressor
• Never bundle output signal lines with high-voltage or power lines, and do not route them in close
proximity or parallel to such lines.
If output signal lines must be routed in close proximity to such lines, place them in separate ducts or
conduits. Be sure to ground the ducts or conduits.
I/O Cable Arrangement
Floor ducts Conduits Suspended ducts
I/O cables
I/O cables
Power lines
Power lines
I/O cables Power lines
• If the signal lines and power lines cannot be routed in separate ducts, use shielded cable. Connect
the shield to the ground terminal at the Panel PC, and leave it unconnected at the input device.
• Wire the lines so that common impedance does not occur. Such wiring will increase the number of
wires, so use common return circuits. Use thick wires with sufficient allowance for the return circuits,
and bundle them with lines of the same signal level.
• For long I/O lines, wire the input and output signal lines separately.
• Use twisted-pair wires for pilot lamps (and particularly lamps with filaments).
• Use countermeasures, such as CR surge absorbers and diodes, for input device and output load
device noise sources, as required.
5 Installation
5-21
NY-series Industrial Panel PC Hardware User's Manual (W555)
5-3 Mount
5
5-3-7
Electrical Environment