16
C200HX/HG/HE(-Z)E: Board Port B Connection
Word Writing
Value
Settings
DM6550
0001
Host link mode, no CTS control, communications conditions
set by the contents of DM
0303
Data length 7 bits, 2 stop bits, even parity, communications
speed: 9600 bps
DM6551
0304
Data length 7 bits, 2 stop bits, even parity, communications
speed: 19200 bps
DM6553
0000
Unit # 00
CPM1 Connection
Word
Writing Value
Settings
DM6650
0001
Host link mode, communications conditions set by the
contents of DM area
0303
Data length 7 bits, 2 stop bits, even parity, communications
speed: 9600 bps
DM6651
0304
Data length 7 bits, 2 stop bits, even parity, communications
speed: 19200 bps
DM6653
0000
Unit # 00
Connecting to a CPM2C
The CPM2C PLCs do not have the same kind of port connectors found on CS-series PLCs.
The CPM2C’s communications port handles both RS-232C and peripheral port connections
which are divided internally. Therefore, when using the CPM2C, it is necessary to select
RS-232C or peripheral port connections, according to the kind of cable and port (on the
cable) used, as shown in the following table. Refer to the
CPM2C Operation Manual
for more
details.
Port connecting to PT
PLC Setup
RS-232C port (D-Sub 9-pin) of CPM2C-CN111
Built-in RS-232C port settings
Peripheral port of CPM2C-CN111
Peripheral port settings
RS-232C port (D-Sub 9-pin) of CS1W-CN118
Built-in RS-232C port settings
Peripheral port of CS1W-CN114
Peripheral port settings
Peripheral port
RS-232C port
(D-Sub 9-pin, female)
RS-232C port
(D-Sub 9-pin, female)
Peripheral port
Setting the DIP Switches of a C200HX/HG/HE(-Z)E, CQM1 or CQM1H
When using a C200HX/HG/HE(-Z)E, CQM1, or CQM1H the DIP switches on the front panel
must be set as shown below in order to make the settings in the PLC Setup area (data
memory) effective.
