6
EN
4. Maintenance
4.1 Maintenance
To protect your monitor from damage, follow the directions below:
Changes or modifications not approved by the manufacturer will void
the user warranty.
4.2 Storage
• Keep your monitor in the storage case when not in use.
1. Remove the arm cuff from the monitor.
2. Gently fold the air tube into the arm cuff.
Note: Do not bend or crease the air tube excessively.
3. Place your monitor and other components in the storage case.
• Store your monitor and other components in a clean, safe location.
• Do not store your monitor and other components:
• If your monitor and other components are wet.
• In locations exposed to extreme temperatures, humidity, direct
sunlight, dust or corrosive vapors such as bleach.
• In locations exposed to vibrations or shocks.
4.3 Cleaning
• Do not use any abrasive or volatile cleaners.
• Use a soft dry cloth or a soft cloth moistened with mild (neutral)
detergent to clean your monitor and arm cuff, and then wipe them
with a dry cloth.
• Do not wash or immerse your monitor and arm cuff or other
components in water.
• Do not use gasoline, thinners or similar solvents to clean your
monitor and arm cuff or other components.
4.4 Calibration and Service
• The accuracy of this blood pressure monitor has been carefully tested
and is designed for a long service life.
• It is generally recommended to have the unit inspected every two
years to ensure correct functioning and accuracy. Please consult your
authorised OMRON dealer or the OMRON Customer Service at the
address given on the packaging or attached literature.
Readings appear too high
or too low.
Blood pressure varies constantly. Many factors including stress, time of day, and/or how you apply
the arm cuff, may affect your blood pressure. Review section 2 of instruction manual
.
Any other communication
issue occurs.
Follow the instructions shown in the smart device, or visit the “Help” section in the “OMRON
connect" app for further help. If the problem still persists, contact your local OMRON
representative.
Any other problem occurs.
Press the [START/STOP] button to turn the monitor off, then press it again to take a measurement.
If the problem continues, remove all batteries and wait for 30 seconds. Then re-install batteries.
If the problem still persists, contact your local OMRON representative.
Display/Problem
Possible Cause
Solution
Caution
DO NOT disassemble or attempt to repair this monitor or other
components. This may cause an inaccurate reading.
Caution
To unplug the air plug, pull on the plastic air plug at the base of the
tube, not the tube itself.
