F3M-S825-1
F3M-S825-1
2
Specifications
J
RATINGS/CHARACTERISTICS
Item
F3M-S825-1
Target object
8-inch semiconductor silicon wafers and transparent wafers
(with transparency of 92% max.) (See Note.)
Number of channels
25
Optical axis pitch
6.35 mm
Optical axis width
1.5 mm
Light source
Infrared LED (940 nm)
Power supply voltage
12 to 24 VDC
r
10%, ripple (p-p): 10% max.
Current consumption
120 mA max.
Output
Control output
Load power supply voltage: 30 VDC
Load current: 20 mA max. (residual voltage: 1 V max.);
Inflow current: 20 mA.;
Parallel output from all channels, NPN open collector;
Dark-ON operation.
Answer-back output
When remote teaching is ON, pin 28 will be used for this function.
Self-diagnostic output
Load power supply voltage: 30 VDC max.;
Load current: 20 mA max.
(Residual voltage: 1 V max.);
Inflow current: 20 mA;
NPN open collector.
Indicators
Power
Green indicator is ON when power is being supplied.
Warning
Red indicator is ON under the following conditions:
Teaching, no target object, insufficient light, or error.
Response time
10 ms max.
Control output interrupt input
All outputs interrupted: GND and control output interrupt input terminals are
short-circuited and 0-V short-circuit current is 1 mA max.;
Output interrupt reset: GND and control output interrupt input terminals are
opened or the voltage is between 9 V and the working power supply
voltage.
Remote teaching input
ON
GND and remote input terminals are short-circuited and 0-V short-circuit
current is 1 mA max.
OFF
GND and remote input terminals are opened or the voltage is between
9 V and the working power supply voltage.
Teaching check function
Orange LED indicator
Ambient temperature
Operating
0
q
C to 40
q
C (32
q
F to 104
q
F) with no icing or condensation
p
Storage
--25
q
C to 60
q
C (--13
q
F to 140
q
F)
Relative humidity
35% to 85% with no condensation
Ambient illumination
Fluorescent lamp: 1,500
ç
x max.
Noise resistance
Power supply line:
r
480 V in normal mode with noise simulator
Static electrical noise: No malfunction or destruction at
r
8 kV
Vibration resistance
10 to 55 Hz, 0.5 mm double amplitude for 2 hrs each in X, Y, and Z axes
Shock resistance
300 m/s
2
(30G) 3 times each in X, Y, and Z axes
Degree of protection
IEC60529 IP40
Connection
Pre-wired cable (length: 500 mm
r
35 mm)
IDC connector (insulation displacement)
Weight (packed state)
Approx. 110 g (3.8 oz)
Material
Optical axis
Polycarbonate
Case
ABS
Cable
Vinyl-insulated, bending type
Accessories
Spacer and instruction manual
Note: Operating conditions are restricted for the detection of transparent wafers. Contact your OMRON representatives for details.
