Omron CS1W-DRM21, Руководство по эксплуатации

Страница: 168 / 379

151
Analog I/O Terminals Section 4-8
DIP Switch Settings The following diagram shows the functions of the DIP switch.
The following table summarizes the DIP switch settings. (All pins are factory-
set to OFF.)
Outputs for “High” and “Low” Clear
Pins 9 and 10 of the DIP switch determine the status of the outputs after a
communications error occurs in DeviceNet communications. The following
table shows the lower and upper limits of the output ranges for each output
signal range setting.
Note Always turn OFF the Slave’s power supply (including the communications
power supply) before changing any settings.
Rotary Switch Setting Set the output signal range for each output with the rotary switch.
The following table shows the rotary switch settings and corresponding output
signal range settings.
Pin(s) Function Settings
1 through 6 Node address setting Refer to 4-8-1 Node Address and Baud Rate
Setting for details.
7 and 8 Baud rate
9 and 10 Output status at com-
munications error.
(See page 154 for
details.)
9 10 Output
OFF OFF Clear at “Low” (see below)
(Factory setting)
OFF ON Clear at “High” (see below)
ON OFF Hold
ON ON Hold
Output signal range “Low” “High”
–10 to 10 V –11 V 11 V
0 to 10 V –0.5 V 10.5 V
1 to 5 V 0.8 V 5.2 V
0 to 20 mA 0 mA 21 mA
4 to 20 mA 3.2 mA 20.8 mA
Node address setting
Baud rate
Output status after
communications error
No. Signal range
for output 0
Signal range
for output 1
0 1 to 5 V 1 to 5 V
1 1 to 5 V 0 to 10 V
2 1 to 5 V –10 to 10 V
3 1 to 5 V 0 to 20 mA
4 1 to 5 V 4 to 20 mA
5 0 to 10 V 0 to 10 V
6 0 to 10 V –10 to 10 V
7 0 to 10 V 0 to 20 mA
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com