Parametereinstellungen (Beispiel)
Hinweis1:
Wenn Sie die geänderte Parametereinstellung nicht übernehmen, sondern verwerfen
möchten, drücken Sie einfach stattdessen die Betriebsartentaste. Anschließend wird
wieder die Parameternummer angezeigt.
2:
Bestimmte Parameter können während des laufenden Frequenzumrichterbetriebs nicht
geändert werden (siehe Parameterliste). Wenn Sie versuchen, einen dieser Parameter zu
ändern, zeigt die Datenanzeige beim Drücken der Erhöhen- oder Verringern-Taste keine
Änderung.
7
Multistep-Drehzahlsollwert 2
13
Frequenzumrichter bereit
8
Multistep-Drehzahlsollwert 3
15
Unterspannung
10
Tippbetrieb
Analoger Überwachungsausgang
12
Externe Endstufensperre (Schließer)
Einstellung
*1
Funktion
13
Externe Endstufensperre (Öffner)
0
Ausgangsfrequenz
17
Umschaltung Lokal / Dezentral
1
Ausgangsstrom
*1 Eine vollständige Liste finden Sie in der Bedienungsanleitung.
Tasten-
Folge
Anzeige
Datenanzeige
(Beispiel)
Erläuterung
Spannung EIN
Drücken Sie wiederholt die Mode Key, bis die PRGM-Anzeige
leuchtet.
Stellen Sie mithilfe der Erhöhen- oder Verringern-Taste die
Parameternummer ein.
Drücken Sie die Eingabetaste. Nun wird die aktuelle Einstellung
des ausgewählten Parameters angezeigt.
Stellen Sie mithilfe der Erhöhen- oder Verringern-Taste den
gewünschten Wert ein.
Dabei blinkt die Datenanzeige.
Drücken Sie die Eingabetaste, um den geänderten Wert zu
übernehmen. Anschließend wird der Wert nicht mehr blinkend,
sondern konstant leuchtend angezeigt (siehe Hinweis 1).
Nach etwa einer
Sekunde
Die Parameternummer wird wieder angezeigt.
Multifunktionseingänge
Multifunktionsausgänge
Einstellung
*1
Funktion
Einstellung
*1
Funktion
Nach etwa einer Sekunde
Änderungen
verwerfen