Omnitronic XFM-212AP, Руководство пользователя

Страница: 17 / 24

17
No. Element Function
1 Audio player with 5
operating buttons [ /MODE]: Long actuation: for switching on/off./For switching between
the USB, SD and Bluetooth operation.
[ /VOL-]/[ /VOL+]: Short actuation: for title selection./ Long actuation:
for volume adjustment.
[REPEAT]: Short actuation: for selecting random play and repeat
functions.
[► II /FOLDER]: Short actuation: for switching between play and pause./
Long actuation: for switching over to folder selection mode.
2 Memory card slot For inserting an SD(HC) card.
3 USB port For connecting a USB storage device.
4 Infrared sensor for the
remote control When actuating a button, always direct the remote control towards the
sensor. There must be no obstacles between remote control and the
sensor.
5 Remote control [► II ]: For switching between play and pause.
[CH-/CH+]: No function
[EQ]: For selecting equalizer settings.
[Vol-/Vol+]: Volume down/up
[ / ]: Previous/next title
[0-9]/[PICK SONG]: Numerical keys for direct selection of a title.
[ENTER]: For selecting equalizer settings.
[MODE]: For switching between the USB, SD and Bluetooth operation.
6 Wireless microphone
with on/off button and
battery indicator Switch lower position = off, center position = mute, upper position = on. If
the LED does not light up with the microphone switched on, the batteries
are exhausted.
7 Reception indicator Lights when an audio signal from the wireless microphone is received.
8 Level control To mix the signal of the wireless microphone to the master signal.
9 Receiver on/off Switches the receiver module on/off. The LED above the button indicates
that the receiving unit is powered on.
10 Microphone input XLR and 6.3 mm input for connecting a microphone.
11 Level control To mix the microphone signal to the master signal.
12 Line input XLR jack and stereo RCA jacks for connecting audio units with line level
(e.g. CD player).
13 Level control To mix the line signal to the master signal.
14 Level control Controls the overall level.
15 Tone controls Controls for the high range (HI) and the low range (LOW) for the mixed
signal.
16 Line output 6.3 mm jack to feed the mixed signal (mono) to units with line level
inputs, e.g. another PA system.
17 Speaker connectors Speaker jack for connecting the passive speaker system.
18 Clip indicator The CLIP LED lights if the internal power amplifier section is overloaded.
Reduce the volume of the signal sources accordingly.
19 Power indicator Lights when the speaker system is powered on.
20 Power on/off Switches the speaker system on/off.
21 Power input with fuse
holder Used to plug in the supplied power cord. Only replace the fuse when the
device is disconnected from mains. Only use fuses of the same rating
and power.