Omnitronic PAS 151A, Руководство пользователя

Страница: 19 / 28

19
•
EN
DJ
FLAT
CH 2 VOL
CH 1
CH 2
CH 1 VOL
LOW
CUT
CH 1 MIXED
MONITOR
LINE IN
DSP
PRESET
L R
MIN MAX
MIN MAX
LINK OUT MIC LINE / IN
LINE MIC
OFF
90Hz
120Hz
AC INPUT
ON
OFF
T3A/250V
190-250 50Hz / 600W
~
Model PAS 212A | 215A
No. Function
1 Status indicators
POWER: speaker is powered on
SIGNAL: input signal is present
LIMIT: the signal level is too high; the limiter
will reduce the signal level to protect the
speakers. Reduce the volume with the master
control until the LED does not light anymore,
or only at signal peaks.
2 Line input channel 1
RCA and XLR/6.3 mm jacks for connecting
audio units with line level output (e.g. mixer,
CD player, music instrument).
3 Feed-through output LINK
Balanced XLR jack to pass either the input
signal of channel 2 or the master signal to
another device, e.g. a further active speaker
system.
4 Output selector switch CH 1/MIXED
Determines the signal at the link output.
• switch disengaged = Output of the input
signal of channel 1
• switch engaged = Output of the master signal.
5 Mic/line input channel 2
Combo input (XLR/6.3 mm jack) for
connecting microphones or audio units with
line level output (e.g. mixer, CD player, music
instrument).
6 LOW CUT switch
To enable a high pass filter. This allows low-
frequency signal components below 90 Hz or
120 Hz (e.g. impact sound) to be suppressed.
7 DSP PRESET switch
To select various equalizer presets: FLAT =
neutral frequency response, DJ = low and
high frequency boost, MONITOR = low and
high frequency cut, mid boost.
8 Level control CH 1 VOL
For adjusting the level of channel 1.
9 Level control CH 2 VOL
For adjusting the level of channel 2.
10 Input selector switch LINE/MIC
Switches the signal input of channel 2
between line and microphone input.
• switch disengaged = microphone input
• switch engaged = line input
11 Fan
Do not cover to avoid overheating.
12 Power switch
Turns power to the speaker system on and off.
13 Power input with fuse holder
Used to plug in the supplied power cord. Only
replace the fuse when the device is
disconnected from mains. Only use fuses of
the same rating and power. The correct fuse
value is specified on the rear panel.