KPA_SERIES_ACTIVE.DOC
31/35
Installation on a stand or speaker stand
The speaker-system may only be installed on a stand or speaker stand if the
original speaker-system is equipped with an appropriate flange.
Stands or satellite systems must only be installed on a plane area with a maximum
inclination angle of 5°.
Caution:
Speaker-systems installed on stands or satellite systems may cause
severe injuries when crashing!
When using stands or satellite systems under the influence of horizontal forces,
e.g. through wind, the standing safety can be impaired. This is why additional
safety measures like attaching ballast weights have to be taken.
If inclined tension cables or prolonged outriggers are used, the area of danger has
to be marked or even be blocked.
Before lifting or lowering the telescopic tubes, you must alway block a safety area
around the stand or satellite system. This safety area must have a diameter of 1.5
times the maximum height.
Lifted telescopic tubes always have to be secured with a secondary securing!
The total weight of the installation (=total weight of all individual parts) must never
exceed the maximum load of the installation area.
The stand has to be installed out of the reach of people.
An unintended movement of the load has to be avoided - also in case of fire!
The installer is responsible for adhering to the carrying capacity given by the manufacturer, the safety
requirements and the qualification of possible co-workers.
When people are located below the load, all necessary safety measures have to be taken in order to avoid
injury.
The personell has to be instructed on the content of the user manual and on the dangers related with
operating stands.
Depending upon the individual installation spot, all necessary measures against movement and for securing
the standing safety have to be created.
The installation is only allowed on carrying areas. In some cases, an appropriate substructure, e.g. via an
balancing foot, has to be created.
The system must never be moved before the top speaker is uninstalled!
When choosing the installation material, optimum dimensions have to be chosen in order to secure
maximum safety.
Loosen the fixation screws of the legs. Pull the legs out until the cross struts stand at a 90° angle to the legs.
Tighten the fixation screws of the legs.
DANGER!
If installing on slippery surfaces, the legs must be secured with screws or nails via the provided
holes or a anti-slippery mat has to be used.
Installation of the TV-pin (only for stands)
Attach an appropriate TV-pin to the top end of the stand and fasten it with the handle at the side.
