00026249.DOC, Version 1.3
41/47
Installation on a wall-mounting
The speaker-system may only be installed on a wall-mounting if the original speaker-system is equipped with
an appropriate flange.
When installed on a wall-mounting, the speaker-system must always be secured with a safety bond.
Before attaching the speaker-system, make sure that the
installation area can hold a minimum point load of 10 times the
installation's weight (e.g. 13 kg weight - 130 kg point load).
The durability of the installation depends very much on the
material used at the installation area (building material) such as
wood, concrete, gas concrete, brick etc. This is why the fixing
material must be chosen to suit the wall material. Always ask a
specialist for the correct plug/screw combination indicating the
maximum load and the building material.
The wall-mounting must always be installed via all fixation holes.
Do only use appropriate screws and make sure that the screws
are properly connected with the ground.
A safety bond which already hold the strain of a crash or which is
defective must not be used again.
The speaker-system must always be secured via an appropriate
eye-bolt.
Procedure:
Step 1:
On the wall-mounting, there are the holes for the installation.
Step 2:
Hold the wall-mounting onto the location where it is to be installed.
Step 3:
Mark the boreholes with a pen or a suitable tool.
Step 4:
Drill the holes.
Step 5:
Hold the wall-mounting in the desired position and tighten the screws.
Step 6:
Insert the eye-bolts into the threaded holes. The eye-bolts must be tightened until stop position,
hand-tight and without any tools.
Step 7:
Install the speaker-system on the wall-mounting.
Step 8:
Insert the quick links of the safety bonds in the eye-bolts of the speaker-system. Pull the safety
bonds through the wall-mounting’s safety eyelet. Insert the end in the quick link and tighten the
safety screw.
The wall mounting's maximum service life must never be exceeded.
