Omnitronic ACS-410BTS, Руководство пользователя

Страница: 21 / 24

21
Setting up a Bluetooth Link between two PA systems
For larger indoor PA applications where the sound has to be radiated as even as possible, two ACS-410BTS
PA systems may be linked via Bluetooth.
1
To activate the Bluetooth module press and hold the PAIR button for 3 seconds after switching on.
2
To link the PA systems shortly press the STEREO LINK button on each unit.
3
The STEREO LINK LED will flash while pairing. It will light solid when the PA systems are linked. To
reset linking press and hold either the STEREO LINK or PAIR button for 3 seconds. NOTE: Initial
linking may take 60+ seconds.
4
Now play music at the Bluetooth source as you normally would and the sound will come out of both PA
systems in stereo. In each case, mix the Bluetooth signal to the master signal using the level control in
channel
CH 5/6 .
..............................................................................................................................................................................
8
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the PA system. Please use a soft lint-free and moistened cloth. Never
use alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers. Should you need any spare parts, please use genuine parts. If
the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
If the stage PA system distorts, one of the loudspeakers may be defective. In this case the system should
not be operated any more in order to prevent further damage. Please contact your dealer. If clacking sounds
are heard from the system, screws may have loosened due to the continuous vibrations. The system should
be checked by a specialist.
Should you have further questions, please contact your dealer.
Replacing the Fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating. Before
replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.