Omnitronic ACS-410BTS, Руководство пользователя

Страница: 18 / 24

18
1
Tone controls HI/LOW
2-band EQ for tuning the tone of the mono inputs CH 1 and 2.
2
Intensity control FX
Adjusts the intensity of the internal reverb effect of the mono inputs CH 1 and 2. The effect can be
turned on and off with the button underneath the control.
3 Volume control LEVEL
To mix the signal of the mono inputs CH 1 and 2 to the master signal.
4
Mono input CH 1/CH 2 with level switch
Balanced combo input (XLR/6.3 mm jack) for the mono inputs CH 1 and 2. Adjust the input level
with the LINE/MIC selector switch: LINE = for audio units with line output (e.g. CD player or
instrument), MIC = for microphones.
5
Stereo input CH 3/4
Unbalanced 6.3 mm and RCA jacks for channel 3/4 for connecting audio units with line output.
6 Volume control LEVEL
To mix the signal of stereo input CH 3/4 to the master signal.
7 Bluetooth buttons STEREO LINK and PAIR
To link two ACS-410BTS systems for wireless stereo operation shortly press the STEREO LINK
button on each unit. To activate the Bluetooth module press and hold the PAIR button for 3
seconds after switching on. Shortly press the PAIR button again to enter the pairing mode. The
LEDs flash while pairing or linking. They light solid when paired or linked. To reset pairing and
linking press and hold either button for 3 seconds. NOTE: Initial pairing or linking may take 60+
seconds.
8
AUX input CH 5/6
3.5 mm jack for connecting portable audio devices without Bluetooth (e.g. MP3 players).
9 LEVEL control
Common level control for the Bluetooth receiver and the AUX input.
10 MONITOR OUT jacks
Unbalanced 6.3 mm jacks for connecting an amplifier of a monitor system.
11 LEVEL control for the monitor output
12 LIMIT indicator
Lights up when the signal level is too high; the limiter will reduce the signal level to protect the
speakers.
13 POWER indicator
14 MASTER LEVEL control for the overall volume
15 Power input
Plug in the supplied power cable here.
16 Fuse
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same
rating and power. The correct fuse value is specified on the rear panel.
17 Power switch
18
SATELLITE OUT speaker connector
Speaker jack for connecting the column speaker.