32
Push & Hold the “Blue FEEDING Button” for four RED flashes of the Status Light and
then Release. The Power Light will FLASH GREEN and the Print Head will move off
the Print Head Capping Station and will go through a purging and wiping routine that
lasts for a minute or more. You will hear the Epson waste pump cycle and see waste
fluid (ink) discharge into the Waste Bottle. Wait for the Cleaning Cycle to end and
the Power Light go to STEADY GREEN.
5. Register the Adult ShirtBoard (Pallet) by placing it on the platform and positioning the
ShirtBoard Base in the front, right corner of the Platform. Slide the ShirtBoard all the
way forward and to the right side. It will hit the raised lip of the Platform and at this
point it is properly registered.
6. Perform the “ShirtBoard Height Adjustment Procedure” to set the ShirtBoard height
for the Nozzle Test print;
a. “Push & Hold” for at least two seconds the “Blue DOWN Button”. This will move
the platform/pallet completely down. If it is already completely down, the motor
will not start. (You can test to make sure the platform is completely down by
Pushing & Releasing the “Blue UP Button” for less than 1 second. The platform
will jog up a small amount and stop when you release the button.) Push & Hold
the Down Button to again lower the ShirtBoard/Platform to the completely down
position.
b. Push and Hold the “Blue FRONT Button” for about 2 seconds until the Printer
Box moves towards the front of the Base about 4 inches and it is over the
ShirtBoard.
c. Now, Push & Hold the “Blue UP Button” for at least two seconds and the
ShirtBoard/Platform will raise up and stop when the edge of the ShirtBoard
“breaks” or interrupts the Infra-Red Laser beam. You have now successfully
adjusted the printing height of the surface of the ShirtBoard to print the Nozzle
Check. NOTE: This adjustment is ONLY good for the Nozzle Check test. You
MUST
perform the ShirtBoard “Height Adjument Procedure”
BEFORE YOU
PRINT ON A GARMENT.
d. If the Print Carriage is not already at the front position, Push & Release the “Red
STAND-BY Button” to move the Printer Box to the “Forward Stand-By Position”
at the front of the Printer Base.
7. Perform a Nozzle Check as follows making sure the following has been done:
a. Computer is ON and connected to the FreeJet320TX printer
b. Epson Print Engine is ON.
c. Head Cleaning has been performed.
d. ShirtBoard Pallet has been registered on Platform
e. ShirtBoard Height Adjustment Procedure has been performed.
f. The Printer Box is in the forward Stan-By position.
¾
On the computer, go to Epson Stylus Photo R2400 printer (in Printer and
Faxes folder in the Control Panel) and select “properties” by “right-
clicking” the printer.
¾
Then select the “Printer Preferences” button (located near the bottom of
the window).
¾
Then select the “Maintenance Tab”.
