5
Using the Extension Rods
Caution:
The safety washer (M)
MUST
be installed whenever using the rod extensions.
There are two situations for using the extension rods:
1. The horizontal distance between the mounting holes on the display, causes the
mounting rails to exceed the maximum 30” (76 cm) width of the standard wall plate. (Fig.
17)
In this case, install all four of the extension rods. Once the extensions are installed, simply
hang the mounting rails onto the outer extensions. (Fig. 18)
2. The lateral adjustment range of the display is limited due to widely spaced mounting rails. (Fig. 19)
In this case, install two extensions rods on the side where the display needs additional range. (Fig. 20)
Re-hang the display with one rail sitting on the extension and the other on the main rod.
Note:
Lateral adjustment range will be limited to a maximum of 6” (15 cm) when using the extension rods. Use care when sliding the display.
To install the extension rods:
1.
Use large hex wrench (supplied) to remove the button head cap from the end of the rod.
2.
Install large round safety washer (M) onto the button head cap, and then thread the cap onto the end
of the extension rod. (Fig. 21)
3.
Thread the extension rod into place. (Fig. 22)
4.
Repeat procedure for each extension rod to be installed.
Note:
The safety washer (M)
MUST
be installed when using the rod extensions, to prevent the display
from being pushed off the mount.
Fig. 17
Fig. 18
Fig. 19
Fig. 20
Fig. 21
Fig. 22