4
Tilt the Display
Important:
Always support the upper edge of the display when adjusting the tilt angle.
To adjust the tilt angle, loosen both tilt tensioning levers just enough so that the display can be moved by applying pressure to the upper edge. With the desired tilt
angle set, re-tighten both tilt tensioning levers. (Fig. 13)
Note:
The tilt tensioning lever includes a ratchet function, so that it can be lifted and repositioned for the next turn. To operate the ratchet, pull the lever
straight out, rotate it to an unobstructed position, release the lever, and then turn it in the desired direction. Repeat as necessary until the tilt tension is set
properly.
Expanding the Mount
With the addition of the supplied
Extension Rails
and
Extension Rods
, the mount can be re-configured for large and wide displays. (Fig. 14)
Using the Extension Rails
On large displays, where the vertical distance between the mounting holes on the back of the display exceed the length of the mounting slots on the standard rails, the mounting rail
extensions must be installed.
To install the rail extensions:
1.
Remove the nuts from the rail extension mounting posts (Fig. 15)
2.
Place rail extension over the standard rail (Fig. 16)
3.
Re-install nuts on mounting posts and tighten securely
Fig. 13
Fig. 14
Fig 15
Fig 16
