035-00708R
R1
2
Running Exposures
1. Enter the RUN screen by touching the icon on the LCD screen.
2. Exposures can be started by the START/STOP switch or by touching
PLAY on the screen.
3. Exposures can be PAUSED and RESUMED until count down timer
has run out. For count up timer, pausing and resuming can be done
indefinitely.
4. To reset an exposure, it is necessary to PAUSE the exposure and
touch the RESET icon. If count down timer has run out, the exposure
will reset automatically.
5. You can exit to the HOME
screen at any time as long as an exposure
is not running (stopped or paused).
Setting the Exposure Time
1. Use the LEFT or RIGHT navigation buttons to change timer when in the Run screen.
2. Or press the timer window on touch screen and enter desired count down time on number pad.
3. Set value to 0 to set Count Up timer.
Setting the Intensity Level
1. Use the UP or DOWN navigation buttons to set intensity.
2. Or press the intensity window on touch screen and enter desired intensity on the number pad.
3. Calibration needs to be performed to enable intensity control in W/cm
2
and W.
Locking and Unlocking the System
1. On the RUN screen, select the LOCK icon and enter the PIN to lock the system (
Default PIN is 1234
)
2. When the system is locked, the user cannot exit the screen or change any of the exposure settings. The user
can only initiate, stop, or reset the exposure using the Start/Stop button, Play Icon, or Foot Pedal. If running a
StepCure
®
profile, user can only initiate, stop, or reset the exposure with the pre-defined inputs.
3. To unlock the system, select the UNLOCK icon and enter the PIN
(Default PIN is 1234).
Note: The PIN can be changed by navigating to Settings
Advanced Setup
Screen Lock Pin.
Using the Foot Pedal / Remote Device (Rear Panel: 3.5mm Jack)
Depressing the foot pedal, or providing a momentary contact closure, provides the same function as pressing the
start/stop button. The shutter opens as per the current mode (Intensity or Timer) of the unit.
