Omnicomm OKO 3.0, Руководство по сборке, Страница: 37 / 56

EN
36
Electronic version
Assembly Instructions
The list and order of execution of all necessary actions for the
installation of the product:
1. Install the video terminal components
2. Insert the SIM card
3. Setup the video cameras
4. Connect the video terminal
5. Configure the video terminal using Omnicomm Configurator
6. Sealing
Video Terminal Components Installation
The video terminal should be installed inside the vehicle cabin or in
designated electrical equipment containers on the vehicle, that are
protected from atmospheric precipitations and humidity.
The video terminal must be installed on a flat surface.
The GLONASS/GPS antenna must be installed on a metal surface. It is
recommended to install the antenna on the roof of the vehicle. It can
be installed on a non-metallic surface if it is secured using glue or
double-sided scotch tape.
The GLONASS/GPS antenna can be installed inside the vehicle, in a
place with a good access to the radio signal from the sky. Inside a
vehicle, the antenna must be installed only on a horizontal surface
and it is necessary to carry out a check the reception quality of the
GLONASS/GPS satellites signal.