OmniCell OmniTT, Инструкция по установке и обслуживанию

Страница: 31 / 41

3-4 Drawers
Installation Procedure
OmniTT/AnesthesiaTT Installation and Service Guide/67-2024 Rev D © 2010 Omnicell, Inc.
The bottom of the bin liner on any matrix drawer is numbered according to its type (i.e. 1-96, 1-
24, 1-4). These numbers are used to identify bin locations for the drawer. The drawer will be
numbered by using the lowest number in a specific bin. Using the figure below as an example, the
bin in the lower right corner of the drawer would be Bin 7, the bin in the upper left corner would
be Bin 49, and the bin in the upper right corner would be Bin 85.
Figure 3-3. Matrix drawer labelling system
Once a bin has been configured, label the bin divider to correspond with the bin name corner and
affix the label to the top of the right rear divider of that bin.
Installation Procedure
1. Perform a graceful shutdown of the TT cabinet.
2. Unlock the manual override cover .
3. Remove the cover by pushing it to the right and lifting it off.
Important:
A Pharmacist must be present when servicing drawers where medications are present.