Omitec OmiDetect 100, Руководство пользователя

Страница: 13 / 29

Setup Procedure
11
The Low Battery Indicator LED (4) illuminates to indicate
OmiDetect’s internal 9 volt battery is low and should be
replaced (see preceding section).
Keypad Buttons
Press to power On/Off the tester and to select the
type of TPM sensor to be tested. Also lets you select
the “Listen” mode to test sensors activated manually,
rather than electronically using OmiDetect.
Press to start testing, causing OmiDetect to activate
the TPM sensor and listen for a valid response RF
signal from it.
5. Operating Instructions
When operating OmiDetect to test a TPM sensor for proper operation,
you will always perform these steps:
1.
Identify the vehicle’s TPM sensor type. (Refer to the Omitec
TPM Sensor Vehicle Application Guide or to the vehicle
manufacturer’s appropriate service information to identify the
type of sensor installed on the vehicle.)
2.
Hold the front end of OmiDetect on or close to the tirewall,
where it meets the wheel rim, directly below the sensor.