OMEN KILO
========
THE BOARD
========
Jumpers and pin headers
--------------------
SERIAL: Serial port. Pins are RxD, TxD, GND from up to the bottom, RxD is near
the edge.
WREN: PLEASE DO NOT USE, just solder the middle pin and the left pin /close to
the BANK switch/ together. I am sorry.
BANK: EEPROM bank selector – only for AT28C256. Leave it open.
NMIX: NMI enabler. Close to disable non-maskable interrupts, open to leave it
on the application bus. Connect the 10k resistor to make it “open-collector
signal”.