Appendix F
ASCII / TELNET COMMANDS TABLE
Command Device / Group ID
Description (see notes below if *)
Example
ERCR
Device ID: 000 – 031
Get continuous readings from an
Get reading for sensor 7,
End Device (only -TC & -VI)
ERCR007
ERDB
Device ID: 000 – 031
Get sensor readings of an End Device
Get reading for sensor 15,
ERDB015
ERDR
Device ID: 000 – 031
Get individual reading or parameter
Get the first temp. reading
Reading/parameter: a-s
*4
for sensor 1, ERDR001c
ERDG
Group ID: 00A - 00D, ALL Get sensor readings of a group /
Get readings for all
*5
groups of sensors
group B, ERDG00B
EQNF
Device ID: 000 – 031
Get name,
*3
status and firmware
Get name for sensor 15,
version of an End Device
EQNF015
EQNG
Group ID00A - 00D, ALL
Get name,
*3
status and firmware
Get name for all sensors,
version of a group/all groups of sensors
EQNGALL
EQPE
Device ID: 000 – 031
Get sleep period, battery voltage, signal Get sleep period for
strength, success, network address and sensor 15, EQPE015
parent address of an End Device
EQPG
Group ID: 00A - 00D
Get sleep period, battery voltage, signal Get sleep period of
strength, success, network address and group B, EQPG00B
parent address of a group / all groups
of sensors
ESPD
Device ID: 000-031, ALL
Set the sleep period for an End Device / Set sensor 15’s sleep
all sensors
*1
period to 30 seconds,
ESPD015 30
ESNM
Device ID: 000 – 031
Set the name of an End Device
*2
Set the name of sensor 15,
ESNM015 z15
ERST
Device ID: 000 – 031, ALL Reset an End Device / all sensors
Reset all sensors,
ERSTALL
ESTR
Device ID: 000 – 031, ALL Request End Device(s) to go into
Put all sensors into
identify mode
identify mode, ESTRALL
ESTP
Device ID: 000 – 031, ALL Request End Device(s) to resume
Resume all sensor to
normal operation
normal operation, ESTPALL
CRST
Reset wireless network
Reset network, CRST
CSTS
Get personal network ID and channel
Get wireless network
information
information, CSTS
FACTORY
Sets the Coordinators Ethernet
FACTORY xxxxxxxx
AdminPassword
configurations to Factory Defaults
xxxxxxxx is the Admin
Password
*1 Argument: 1 – 32767 (1 seconds to about 9 hours)
*2 Argument: xxxxxxxx (8 characters)
*3 and *4 See the following page
*5 Refer to
Section 4.5.1
HTTPget using Port 2000
75
