PART 2 HARDWARE
2.1a Parts of the End Device (zED-P/-LCD/-AA)
1
8 position DIP switch (under cover), sets the NID and DID of the End Device
(see
Section 2.7
for details)
2
Power Switch
3
Label for Unit Address, Group No. and Network ID Address (NID)
4
Wall mounting holes
5
Label with part and serial numbers
6
Radio module firmware revision location on label
7
Case’s tray, where the PCB, sensor and batteries are mounted
8
Case’s cover
9
Transmit LED (blue)
10
4 Screws attaching Cover
11
External probe/sensor, through cable gland (for zED-TC-x) or quick
disconnect connector . Refer to
Figure 2.2a
for connector configurations.
12
Power Input, through quick disconnect connector (for zED-P & zED-LCD)
13
Antenna Mount
14
Thermocouple (if ordered) removable terminal block connector (under cover)
15
LCD Display (for zED-LCD & zED-LCD-AA)
16
Two AA alkaline batteries (for zED-LCD-AA) or one lithium back-up battery
(for zED-P & zED-LCD) (located under cover)
Figure 2.1a Parts of the End Device (zED-P/-LCD/-AA)
Warning:
the following parts are
ESD sensitive.
5
