3-6
Software
3
3.4 UWTC Universal Wireless End Device Configuration Wizard
This utility is used to program your connector/transmitter for the following
operating parameters: Thermocouple Type, Channel Number and Sample
Rate. For complete instructions on using this program please see Section 4.
3.5 TC-Central Measurement and Recording Program
To launch the TC-Central program on your PC begin by accessing the
“Programs” list under your “Start Menu” Next, scroll through the list of
program folders to find the “TC-Central” folder. Inside the “TC-Central”
folder click on the “TC-Central” program link. This will start the software
running.
3.5.1 Channels TAB
When TC-Central starts up, the “Channels” tab is displayed. This view allows
you to see temperatures and properties for up to 48 connector/transmitter at
one time by using the scroll bar to the right of the screen.
Figure 3-9. TC-Central Program Screen
This is a view of the TC-Central Program in operation. You will not have any
blocks receiving data until you have programmed and placed into operation
your connector/transmitters.
3.5.2 Setting up the TC-Central Program
Before you can make wireless measurements with your connector/transmitter
the TC-Central software must be configured properly. The following steps
outline how to setup your program.
