[Grab
Operating instructions
3.2 Button and key Layout:
1) Trigger
2) Back light/Up Button
3) Mode button
4) T/Down Button
5) SET Button
6) LCD Display
7) Battery Door
8) Laser Button
3.3 Operating Steps
1) Hold the thermometer by the handle grip and point it towards the surface to be measured.
2) Pull and hold the trigger to turn the thermometer on. The “SCAN” icon will appear on the top line of the display.
3) The surface temperature being measured will be displayed on the LCD screen.
4) When the trigger is released, the “HOLD” icon will appear and the last reading seen will remain on the display screen.
5) The thermometer will automatically turn off after 7 seconds of inactivity.
3.4 Button function
3.4.1 Mode Selection
1) With trigger held, press the “MODE” button [3] to cycle through the different modes.
a. “AVG” displays average temperature reading seen during the session.
b. “MAX” displays maximum temperature reading seen during session.
c. “MIN” displays minimum temperature reading seen during session.
d. “HAL” shows High Alarm value (use UP and DN buttons to adjust up or down).
e. “LAL” shows Low Alarm value (use UP and DN buttons to adjust up or down).
3.4.2 Changing Temperature Units
1) With trigger [1] held and “SCAN” shown on display, press “T/DN” [4] to toggle between °C
and °F.
1
7
6
5
4
3
2
8
