07
User Manual
Installation Safety Instructions
• WARNING:
Please ensure that all power is switched off
before installing the rangehood.
• IMPORTANT:
Before installing your rangehood, please
record the details of your rangehood’s rating label (located
within the rangehood, behind the aluminium grease filters)
into the form on page 12. This will be helpful should you
need to contact our service team in the future.
•
Installation must be in accordance to the local electrical
authority and codes.
•
The switched power outlet for the range hood should be
positioned to enable the user to turn the power off, to
enable cleaning and any maintenance required.
•
The switched power outlet should be installed within
600mm from the rear of the unit.
•
Ensure that when installing the rangehood, that it is
protected from any possible damage from tools etc.
•
Ducting for this unit must be installed in accordance
to the local authority.
•
Ensure that the fixings used for installing this rangehood
are suitable.
•
Check the area where the rangehood is to be fitted,
to ensure that it is structurally sound.
•
Before using the appliance, remove the plastic coatings
protecting the stainless-steel finish.
•
These models are intended to be installed into the kitchen
cabinetry.
•
Take care that the cabinetry and supporting wall can carry
the weight of the rangehood.
•
Always double-check dimensions in this manual against
the appliance before commencing.
•
The rangehood should be placed at a minimum distance of
650mm from the cooking surface of the cooker below. Any
more than 750mm could compromise the performance of
the appliance.
•
Drill a cut-out hole into the cupboard according to the table
on page 5 based on your model.
•
Make sure the distance between the edge of the hole
and the edge of the cupboard edge is at least 35mm.
•
Remove the filter and remove the four screws holding
the lower panel in place.
•
Lift the appliance into the cut-out hole and check that it
fits correctly (no gaps, does not interfere with anything
above it etc.).
•
Mark the hole positions with a pencil, remove the appliance
and pre-drill the holes using a small drill bit.
•
Place the appliance back into position, line up the holes
and fix into place using the 8 screws provided.
•
Replace the cover & fix into position with the 4 screws
and fit the filter.
•
Fit the one-way filter to the top of the unit.
•
The exhaust air vents through the one-way valve
at the top.
•
If the exhaust is to be vented away, cut a hole (~Ø160mm)
in the top of the cupboard, and connect Ø150mm ducting
to the one-way valve & pass it through the hole to wherever
it is going.
•
If the exhaust air is to be recirculated back into the
room, either cut vents into the cupboard (with a minimum
area of 800cm²), or leave the cupboard door open when
in use.
•
Once assembled in place, the appliance can be connected
to the power supply.
Installation Instructions
(Continued)
Содержание ORU52XL
Страница 13: ...13 User Manual Notes...
