Omega ORF60XL, Инструкция по эксплуатации

Страница: 6 / 12

6
Installation Instructions
Method two (Mounting under a Cupboard):
1. Drill 4 holes of Ø 6mm at the bottom of the hanging cupboard.
2. Put the one-way valve on the cooker hood, then install the cooker hood on the bottom of the
cupboard, tighten the hood with enclosed 4 screws (M4*35mm).
3. Install the adjusted board on the bottom of the hood in order to keep out the gap between hood
back and cupboard.
ORF60XL ORF90XL
Venting Options:
There are two methods for ventilating the exhaust fumes; rear ventilation and top ventilation. Please pay
attention to the ventilation method when installing.
Rear ventilation: As shown in pic. 4A, please use the cover to seal the outlet on the top, then the air can
be vented from the back.
Top ventilation: As shown in pic 4B, please use the cover to seal the outlet on the back, then the air can
be vented from the top.
Recirculating or Ducted Venting:
The rangehood can be installed to vent the exhaust
fumes out of the room (ducted) or to recirculate the
air back into the room once it has been filtered
(recirculating).
To set the rangehood up to vent the exhaust fumes
out of the room, adjust the venting switch (internal
between the fans) forward and choose a venting
system (rear or top). This is shown in Pics 5A & 5C.
To set the rangehood up to vent back into the room,
block the rear and top outlets and adjust the venting
switch to the rear. This will vent the exhaust fumes
through the vents at the front of the rangehood. This is shown in PIC 5B & 5D. Note that carbon filters must
also be fitted to the fan inlets as shown.
7
Operating Instructions
The controls are at the front of the rangehood.
SPEED ADJUSTMENT:
1. Push ‘Stop’ button, and the motor will stop.
2. Push the ‘Low’ button, the buzzer will buzz once,
and the motor runs at low speed.
3. Push the ‘Mid’ button, the buzzer will buzz once,
and the motor runs at mid speed.
4. Push the ‘High’ button, the buzzer will buzz once, and the motor runs at high speed.
5. Push the ‘Light’ button and the two lights will come on. Push it again and the light will turn off.
Cleaning
SAFETY PRECAUTION
Before cleaning your rangehood or performing any maintenance, please ensure that the range hood is
turned off at the power point.
Do not use abrasive cleaners to clean the range hood. The use of warm soapy water and a cloth is
recommended.
Ensure that the range hood is cleaned regularly, as a build-up of grease and fat may occur otherwise.
The filters on the range hood must be cleaned regularly to maintain efficiency, and prevent grease build up.
The filter mesh is made of metal. It is recommended that this is undertaken every 4 – 6 weeks, depending
on frequency of use. The filters can be cleaned with warm soapy water or a cloth.
Cleaning of the range hood must be performed as described above; otherwise there is a possibility of a fire
hazard due to grease and fat build up.
Replacing the Lamps
1. Before changing the lights, make sure that the appliance is unplugged from the power source.
2. Open the filter.
3. Change the 2W LED lamp an identical bulb:
a. Max Wattage: 2W
b. Voltage Range: 220 – 240V AC
c. ILCOS D Code: DBS-2/65-H-120/33
4. Replace the filter to the original position.