Omega OO885XR, Инструкции по эксплуатации и монтажу

Страница: 15 / 22

12
USING THE DISPLAY
The electronic programmer incorporates the
following functions:

24 hour clock with luminous display

24 hour timer

Automatic cooking

Semiautomatic cooking
The electronic programmer operates only on the
main lower oven.
Symbols
When this symbol is displayed, the oven will operate when the temperature and
cooking function are set. This symbol is normally on, and will turn off after automatic
cooking has completed.
This symbol is shown when the beep timer is set. If it is blinking, this means that the
beep timer has finished.
This symbol is shown when the oven is operating in automatic cooking mode. If it is
blinking, this means that automatic cooking mode has completed, or hasn’t been set
correctly.
Digital Clock
The timer incorporates a digital electronic clock with luminous numbers indicating the hours
and minutes. When the oven is first connected to an A.C. supply, or following a power cut,
three zeroes will blink in the timer window. To set the clock, hold
and at the same time
until you hear a beep, then release them. Use and to adjust the clock to the correct time.
Holding the button will cause the time to adjust quicker. Once the time has been set, wait
approximately seven seconds until you hear a beep confirming the time has been set
.
Normal cooking without using the timer
To operate the oven in manual mode – in other words, without using the automatic timer – the
“
AUTO ” symbol must not be active.
Beep Timer
To set the beep timer, hold the centre button for approximately three seconds until you hear a
beep and the display shows the
symbol flashing. Use the and buttons to adjust the
timer to the required time. Once the time is set, press the centre button again until the display
returns to the current time. The
will show solid and will no longer be flashing. The timer is
now set. Once the timer runs out, the oven will beep. Press the centre butter to stop this.