11
User Manual
Levelling the Dishwasher:
To ensure optimal dish rack operation and wash
performance, it is imperative that the dishwasher is perfectly
level. Follow the steps below to achieve proper levelling:
•
Position a spirit level on the door and the rack track inside
the tub, as indicated in the provided illustration, to verify
the dishwasher's levelness.
•
Adjust the dishwasher's level by manipulating the three
levelling legs individually.
•
Exercise caution while levelling the dishwasher to prevent
it from tipping over.
NOTE:
The maximum adjustment height of the levelling feet
is 50 mm.
Adjusting the Door spring tension
The door springs are set at the factory default tension for the
outer door. Once the Aesthetic Door Panel is installed, you
will have to adjust the door spring tension.
•
Rotate the adjusting screw to tighten or loosen the door
steel cable (refer to Figure 3).
•
The door spring tension is correct when the door remains
horizontal in the fully opened position, yet rises to a close
with the slight lift of a finger.
Installation Instructions
(Continued)
FIGURE 3
A. Wood Surface
B. Marble or
Granite Surface
UP
DOWN
Check level
front to back
Check level
side to side
Step 5. Levelling the dishwasher
Dishwasher must be level for proper dish rack operation and wash performance.
Place a spirit level on door and rack track inside the tub as shown to check that the
dishwasher is level.
Level the dishwasher by adjusting the three levelling legs individually.
When level the dishwasher, please pay attention not to let the dishwasher tip over.
1.
2.
3.
The maximum adjustment height of the feet is 50 mm.
NOTE
:
22
FIGURE 1
Step 3. Tension adjustment of the door spring
1.
The door springs are set at the factory to
the proper tension for the outer door. If
aesthetic wooden panel are installed, you
will have to adjust the door spring tension.
Rotate the adjusting screw to drive the
adjustor to strain or relax the steel cable.
2.
Door spring tension is correct when the
door remains horizontal in the fully opened
position, yet rises to a close with the slight
lift of a finger.
Install the hook on the aesthetic wooden panel and put the hook into the slot of the
outer door of dishwasher (see figure A). After positioning of the panel, fix the panel
onto the outer door by screws and bolts (See figure B).
B
2
.
Pin up the four long screws
A
1
.
Take away the four short screws
Full-integrated
model
20
FIGURE 2
