Omega ODW101W, Инструкция по эксплуатации

Страница: 5 / 26

5
Installation Instruction
Warning: The installation of the pipes and electrical equipments should be done by qualified professionals.
Electrical Shock Hazard: Disconnect electrical power before installing dishwasher. Failure to do so can
result in death or electrical shock.
Installation preparation
The installation position of dishwasher should be near the existing water inlet tap and drain outlet and
power socket.
One side of the cabinet sink should be chosen to facilitate the connection of drain hoses of the dishwasher.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can
be positioned to the right or the left to facilitate proper installation.
About Power Connection
For personal safety:
■
Do not use an extension cord or an adapter plug with this appliance.
■
Do not cut or remove the earthing under any circumstances.
■
Connection from the power cord.
Electrical Requirements
Please look at the rating label to know the rating voltage and connect the dishwasher to the appropriate
power supply. Use the required fuse 10 amp, time delay fuse or circuit breaker recommended and provide
separate circuit serving only this appliance.
Electrical Connection
Ensure the voltage and frequency of the power being corresponds to those on the rating plate. Only insert
the plug into an electrical socket which is earthed properly. If the electrical socket to which the appliance
must be connected is not appropriate for the plug, replace the socket, rather than using a adaptors or the
like as they could cause overheating and burns.
Water Connection
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened
tightly in place. If the water pipes are new or have not been used for an extended period of time, let the
water run to make sure that the water is clear and free of impurities. If this precaution is not taken, there is a
risk that the water inlet can get blocked and damage the appliance.
Please note: If the supplied hose not fit your tap, please contact your local plumbing supply center where
adapters are available for purchase.
WARNING: Close hydrant after using